Installation manual

4-328
SIGNAMAX LLC • www.signamax.eu
Default Setting
Deny
Command Mode
Interface Configuration
Command Usage
When the maximum number of groups is reached on a port, the switch can take
one of two actions; either “deny” or “replace.” If the action is set to deny, any new
IGMP join reports will be dropped. If the action is set to replace, the switch
randomly removes an existing group and replaces it with the new multicast group.
Example
show ip igmp filter
This command displays the global and interface settings for IGMP filtering.
Syntax
show ip igmp filter [interface interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp max-groups action replace
Console(config-if)#
Console#show ip igmp filter
IGMP filter enabled
Console#show ip igmp filter interface ethernet 1/1
Ethernet 1/1 information
---------------------------------
IGMP Profile 19
Deny
range 239.1.1.1 239.1.1.1
range 239.2.3.1 239.2.3.100
Console#