Installation manual

4-325
SIGNAMAX LLC • www.signamax.eu
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
A profile defines the multicast groups that a subscriber is permitted or denied to
join. The same profile can be applied to many interfaces, but only one profile can
be assigned to one interface. Each profile has only one access mode; either permit
or deny.
Example
permit, deny
This command sets the access mode for an IGMP filter profile. Use the no form to delete
a profile number.
Syntax
{permit | deny}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
• Each profile has only one access mode; either permit or deny.
• When the access mode is set to permit, IGMP join reports are processed when a
multicast group falls within the controlled range. When the access mode is set to
deny, IGMP join reports are only processed when a multicast group is not in the
controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#