Installation manual

4-319
SIGNAMAX LLC • www.signamax.eu
Example
ip igmp snooping query-count
This command configures the query count. Use the no form to restore the default.
Syntax
ip igmp snooping query-count count
no ip igmp snooping query-count
count - The maximum number of queries issued for which there has been no
response before the switch takes action to drop a client from the multicast
group. (Range: 2-10)
Default Setting
2 times
Command Mode
Global Configuration
Command Usage
The query count defines how long the querier waits for a response from a multicast
client before taking action. If a querier has sent a number of queries defined by this
command, but a client has not responded, a countdown timer is started using the
time defined by ip igmp snooping query-max- response-time. If the countdown
finishes, and the client still has not responded, then that client is considered to have
left the multicast group.
Example
The following shows how to configure the query count to 10:
Related Commands
ip igmp snooping query-max-response-time (4-320)
Console(config)#ip igmp snooping querier
Console(config)#
Console(config)#ip igmp snooping query-count 10
Console(config)#