Installation manual

4-303
SIGNAMAX LLC • www.signamax.eu
Default Setting
None
Command Mode
Privileged Exec
Example
Related Commands
map ip dscp (Global Configuration) (4-301)
map ip dscp (Interface Configuration) (4-301)
Quality of Service Commands
The commands described in this section are used to configure Differentiated Services
(DiffServ) classification criteria and service policies. You can classify traffic based on
access lists, IP Precedence or DSCP values, or VLANs. Using access lists allows you
select traffic based on Layer 2, Layer 3, or Layer 4 information contained in each packet.
Console#show map ip dscp ethernet 1/1
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0 0
Eth 1/ 1 1 0
Eth 1/ 1 2 0
Eth 1/ 1 3 0
.
.
.
Eth 1/ 1 61 0
Eth 1/ 1 62 0
Eth 1/ 1 63 0
Console#
Table 4-81 Quality of Service Commands
Command Function Mode Page
class-map Creates a class map for a type of traffic GC 4-304
match Defines the criteria used to classify traffic CM 4-305
rename Redefines the name of a class map CM 4-306
description Specifies the description of a class map CM 4-306
policy-map Creates a policy map for multiple interfaces GC 4-307
class Defines a traffic classification for the policy to act on PM 4-308
rename Redefines the name of a policy map PM 4-306
description Specifies the description of a policy map PM 4-306
set Classifies IP traffic by setting a CoS or DSCP value in a
packet
PM-C 4-309