Installation manual

4-282
SIGNAMAX LLC • www.signamax.eu
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The management address protocol packet includes the IPv4 address of the switch.
If no management address is available, the address should be the MAC address
for the CPU or for the port sending this advertisement.
• The management address TLV may also include information about the specific
interface associated with this address, and an object identifier indicating the type of
hardware component or protocol entity associated with this address. The interface
number and OID are included to assist SNMP applications to perform network
discovery by indicating enterprise specific or other starting points for the search,
such as the Interface or Entity MIB.
• Since there are typically a number of different addresses associated with a Layer 3
device, an individual LLDP PDU may contain more than one management address
TLV.
• Every management address TLV that reports an address that is accessible on a
port and protocol VLAN through the particular port should be accompanied by a
port and protocol VLAN TLV that indicates the VLAN identifier (VID) associated
with the management address reported by this TLV.
Example
lldp basic-tlv port-description
This command configures an LLDP-enabled port to advertise its port description. Use the
no form to disable this feature.
Syntax
[no] lldp basic-tlv port-description
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port description is taken from the ifDescr object in RFC 2863, which includes
information about the manufacturer, the product name, and the version of the
interface hardware/software.
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#