Installation manual

4-281
SIGNAMAX LLC • www.signamax.eu
lldp mednotification
This command enables the transmission of SNMP trap notifications about LLDP-MED
changes. Use the no form to disable LLDP-MED notifications.
Syntax
[no] lldp mednotification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at the
interval specified by the lldp notification-interval command (page 4-277). Trap
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or organization-specific
LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command
(page 4-87).
• Information about additional changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a trap
notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect any
lldpRemTablesChange notification-events missed due to throttling or transmission
loss.
Example
lldp basic-tlv management-ip-address
This command configures an LLDP-enabled port to advertise the management address
for this device. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv management-ip-address
Default Setting
Enabled
Console(config)#interface ethernet 1/1
Console(config-if)#lldp mednotification
Console(config-if)#