Installation manual

4-278
SIGNAMAX LLC • www.signamax.eu
lldp refresh-interval
This command configures the periodic transmit interval for LLDP advertisements. Use the
no form to restore the default setting.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are
sent. (Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Command Usage
This attribute must comply with the following rule:
(refresh-interval * holdtime-multiplier) ≤
65536
Example
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP ports are
disabled or the link goes down. Use the no form to restore the default setting.
Syntax
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP. (Range: 1
- 10 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems LLDP
MIB associated with this port is deleted.
Console(config)#lldp refresh-interval 60
Console(config)#