Installation manual

4-271
SIGNAMAX LLC • www.signamax.eu
Command Mode
Interface Configuration
Command Usage
• When OUI is selected, be sure to configure the MAC address ranges in the
Telephony OUI list (see the voice vlan mac-address command on page 4-269).
MAC address OUI numbers must be configured in the Telephony OUI list so that
the switch recognizes the traffic as being from a VoIP device.
• LLDP checks that the “telephone bit” in the system capability TLV is turned on. See
“Spanning Tree Commands” on page 4-216 for more information on LLDP.
Example
The following example enables the OUI method on port 1 for detecting VoIP traffic.
switchport voice vlan security
This command enables security filtering for VoIP traffic on a port. Use the no form to
disable filtering on a port.
Syntax
[no] switchport voice vlan security
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
• Security filtering discards any non-VoIP packets received on the port that are
tagged with the voice VLAN ID. VoIP traffic is identified by source MAC addresses
configured in the Telephony OUI list, or through LLDP that discovers VoIP devices
attached to the switch. Packets received from non-VoIP sources are dropped.
• When enabled, be sure the MAC address ranges for VoIP devices are configured
in the Telephony OUI list (voice vlan mac-address, page 4-269).
Example
The following example enables security filtering on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan rule oui
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan security
Console(config-if)#