Installation manual

4-262
SIGNAMAX LLC • www.signamax.eu
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
All ports assigned to a secondary (i.e., community) VLAN can pass traffic between
group members, but must communicate with resources outside of the group via
promiscuous ports in the associated primary VLAN.
Example
switchport private-vlan mapping
Use this command to map an interface to a primary VLAN. Use the no form to remove
this mapping.
Syntax
switchport private-vlan mapping primary-vlan-id
no switchport private-vlan mapping
primary-vlan-id – ID of primary VLAN. (Range: 1-4094, no leading zeroes).
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Promiscuous ports assigned to a primary VLAN can communicate with any other
promiscuous ports in the same VLAN, and with the group members within any
associated secondary VLANs.
Example
Console(config)#interface ethernet 1/3
Console(config-if)#switchport private-vlan host-association 3
Console(config-if)#
Console(config)#interface ethernet 1/2
Console(config-if)#switchport private-vlan mapping 2
Console(config-if)#