Installation manual

4-256
SIGNAMAX LLC • www.signamax.eu
pvlan uplink/downlink
This command configures uplink/downlink ports for traffic-segmentation client sessions.
Use the no form to restore a port to normal operating mode.
Syntax
[no] pvlan [session session-id] {uplink interface-list [downlink interface-list] |
downlink interface-list}
• session-id – Traffic segmentation session. (Range: 1-15)
• interface-list – One or more uplink or downlink interfaces.
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A port cannot be configured in both an uplink and downlink list.
• A port can only be assigned to one traffic-segmentation session.
• A downlink port can only communicate with an uplink port in the same session.
Therefore, if an uplink port is not configured for a session, the assigned downlink
ports will not be able to communicate with any other ports.
• If a downlink port is not configured for the session, the assigned uplink ports will
operate as normal ports.
• Due to switch ASIC limitations, ports 1-8, 9-16, 17-24 are grouped together when
any group member is configured as an uplink or downlink interface.
Example
pvlan session
This command creates a traffic-segmentation client session. Use the no form to remove a
client session.
Syntax
[no] pvlan session session-id
session-id – Traffic segmentation session. (Range: 1-15)
Default Setting
None
Console(config)#pvlan session 1 uplink ethernet 1/5 downlink ethernet 1/6
Console(config)#