Installation manual

4-255
SIGNAMAX LLC • www.signamax.eu
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• When traffic segmentation is enabled, the forwarding state for the uplink and
downlink ports assigned to different client sessions is shown below.
• When traffic segmentation is disabled, all ports operate in normal forwarding mode
based on the settings specified by other functions such as VLANs and spanning
tree protocol.
Example
Table 4-71 Traffic Segmentation Forwarding
Destination
Source
Session #1
Downlinks
Session #1
Uplinks
Session #2
Downlinks
Session #2
Uplinks
Normal
Ports
Session #1
Downlink Ports
Blocking Forwarding Blocking Blocking Blocking
Session #1
Uplink Ports
Forwarding Forwarding Blocking Blocking/
Forwarding
*
* The forwarding state for uplink-to-uplink ports is configured by the pvlan uplink/downlink
command (page 4-256).
Forwarding
Session #2
Downlink Ports
Blocking Blocking Blocking Forwarding Blocking
Session #2
Uplink Ports
Blocking Blocking/
Forwarding
*
Forwarding Forwarding Forwarding
Normal Ports Forwarding Forwarding Forwarding Forwarding Forwarding
Console(config)#pvlan
Console(config)#