Installation manual

4-243
SIGNAMAX LLC • www.signamax.eu
• no vlan vlan-id state returns the VLAN to the default state (i.e., active).
• You can configure up to 255 VLANs on the switch.
Note:
The switch allows 255 user-manageable VLANs. One extra, unmanageable VLAN
(VLAN ID 4093) is maintained for switch clustering.
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN is
activated by default.
Related Commands
show vlan (4-249)
Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is used to configure
VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading zeroes)
Default Setting
None
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Table 4-67 Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for a specified VLAN GC 4-243
switchport mode Configures VLAN membership mode for an interface IC 4-244
switchport
acceptable-frame-types
Configures frame types to be accepted by an interface IC 4-245
switchport ingress-filtering Enables ingress filtering on an interface IC 4-245
switchport native vlan Configures the PVID (native VLAN) of an interface IC 4-246
switchport allowed vlan Configures the VLANs associated with an interface IC 4-247
switchport gvrp Enables GVRP for an interface IC 4-239
switchport forbidden vlan Configures forbidden VLANs for an interface IC 4-248
switchport priority default Sets a port priority for incoming untagged frames IC 4-297