Installation manual

4-237
SIGNAMAX LLC • www.signamax.eu
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how VLAN
tagging is used, and enable automatic VLAN registration for the selected interface.
GVRP and Bridge Extension Commands
GARP VLAN Registration Protocol defines a way for switches to exchange VLAN
information in order to automatically register VLAN members on interfaces across the
network. This section describes how to enable GVRP for individual interfaces and globally
for the switch, as well as how to display default configuration settings for the Bridge
Extension MIB.
Table 4-64 VLANs
Command Groups Function Page
GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
4-237
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 4-241
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
4-243
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses 4-249
Configuring 802.1Q
Tunneling
Configures 802.1Q Tunneling (QinQ Tunneling) 4-250
Configuring Port-based
Traffic Segmentation
Configures traffic segmentation for different client sessions based on
specified downlink and uplink ports
4-254
Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-258
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-263
Configuring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN 4-267
Table 4-65 GVRP and Bridge Extension Commands
Command Function Mode Page
bridge-ext gvrp Enables GVRP globally for the switch GC 4-238
show bridge-ext Shows the global bridge extension configuration PE 4-238
switchport gvrp Enables GVRP for an interface IC 4-239
switchport forbidden vlan Configures forbidden VLANs for an interface IC 4-248
show gvrp configuration Displays GVRP configuration for the selected interface NE, PE 4-239
garp timer Sets the GARP timer for the selected function IC 4-240
show garp timer Shows the GARP timer for the selected function NE, PE 4-241