Installation manual

4-225
SIGNAMAX LLC • www.signamax.eu
Default Setting
32768
Command Mode
MST Configuration
Command Usage
• MST priority is used in selecting the root bridge and alternate bridge of the specified
instance. The device with the highest priority (i.e., lowest numerical value)
becomes the MSTI root device. However, if all devices have the same priority, the
device with the lowest MAC address will then become the root device.
• You can set this switch to act as the MSTI root device by specifying a priority of 0,
or as the MSTI alternate device by specifying a priority of 16384.
Example
name
This command configures the name for the multiple spanning tree region in which this
switch is located. Use the no form to clear the name.
Syntax
name name
name - Name of the spanning tree.
Default Setting
Switch’s MAC address
Command Mode
MST Configuration
Command Usage
The MST region name and revision number (page 4-226) are used to designate a
unique MST region. A bridge (i.e., spanning-tree compliant device such as this
switch) can only belong to one MST region. And all bridges in the same region must
be configured with the same MST instances.
Example
Related Commands
revision (4-226)
Console(config-mstp)#mst 1 priority 4096
Console(config-mstp)#
Console(config-mstp)#name R&D
Console(config-mstp)#