Installation manual

4-211
SIGNAMAX LLC • www.signamax.eu
Rate Limit Commands
This function allows the network manager to control the maximum rate for traffic received
on an interface. Rate limiting is configured on interfaces at the edge of a network to limit
traffic into the network. Packets that exceed the acceptable amount of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface is configured
with this feature, the traffic rate will be monitored by the hardware to verify conformity.
Non-conforming traffic is dropped.
rate-limit
Use this command to define the rate limit level for a specific interface. Use this command
without specifying a rate to restore the default rate limit. Use the no form to restore the
default status of disabled.
Syntax
rate-limit {input | output} [rate]
no rate-limit <input | output>
• input – Input rate limit
• output – Input rate limit
• rate – The traffic rate limit level. Range: 64-100000 kilobits per second for
100 Mbps ports; 64-1000000 kilobits per second for 1 Gbps ports
Default Setting
Status: Disabled
Rate Limit: 100000 kilobits per second for 100 Mbps ports; 1000000 kilobits per
second for 1 Gbps ports
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Table 4-58 Rate Limit Commands
Command Function Mode Page
rate-limit Configures the maximum input rate for a port IC 4-211
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 2000
Console(config-if)#