Installation manual

4-205
SIGNAMAX LLC • www.signamax.eu
lacp port-priority
This command configures LACP port priority. Use the no form to restore the default
setting.
Syntax
lacp {actor | partner} port-priority priority
no lacp {actor | partner} port-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - LACP port priority is used to select a backup link. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Setting a lower value indicates a higher effective priority.
• If an active port link goes down, the backup port with the highest priority is selected
to replace the downed link. However, if two or more ports have the same LACP port
priority, the port with the lowest physical port number will be selected as the backup
port.
• Once the remote side of a link has been established, LACP operational settings are
already in use on that side. Configuring LACP settings for the partner only applies
to its administrative state, not its operational state, and will only take effect the next
time an aggregate link is established with the partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor port-priority 128
Console(config-if)#