Installation manual

4-201
SIGNAMAX LLC • www.signamax.eu
Command Usage
• When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
•Use no channel-group to remove a port group from a trunk.
•Use no interfaces port-channel to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11:
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP) for the current
interface. Use the no form to disable it.
Syntax
[no] lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The ports on both ends of an LACP trunk must be configured for full duplex, and
auto-negotiation.
• A trunk formed with another switch using LACP will automatically be assigned the
next available port-channel ID.
• If the target switch has also enabled LACP on the connected ports, the trunk will be
activated automatically.
• If more than eight ports attached to the same target switch have LACP enabled, the
additional ports will be placed in standby mode, and will only be enabled if one of
the active links fails.
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#