Installation manual

4-198
SIGNAMAX LLC • www.signamax.eu
Command Usage
If no interface is specified, information on all interfaces is
displayed.
Example
This example shows the configuration setting for port 24.
Console#show interfaces switchport ethernet 1/24
Broadcast Threshold: Enabled, 64 Kbits/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, 100000 Kbits per second
Egress Rate Limit: Disabled, 100000 Kbits per second
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
Console#
Table 4-51 show interfaces switchport - display description
Field Description
Broadcast Threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 4-193).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 4-201).
Ingress Rate Limit Shows if ingress rate limiting is enabled, and the current rate limit. (page 4-211).
Egress Rate Limit Shows if egress rate limiting is enabled, and the current rate limit. (page 4-211).
VLAN Membership Mode Indicates membership mode as Trunk or Hybrid (page 4-244).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 4-245).
Note: Ingress filtering is always enabled.
Acceptable Frame Type Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-245).
Native VLAN Indicates the default Port VLAN ID (page 4-246).
Priority for Untagged
Traffic
Indicates the default priority for untagged frames (page 4-273).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled (page 4-239).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 4-247).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP (page 4-248).
Private-VLAN Mode Shows the private VLAN mode as host, promiscuous, or none (4-261).