Installation manual

4-189
SIGNAMAX LLC • www.signamax.eu
Related Commands
negotiation (4-189)
capabilities (4-190)
negotiation
This command enables autonegotiation for a given interface. Use the no form to disable
autonegotiation.
Syntax
[no] negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When auto-negotiation is enabled the switch will negotiate the best settings for a
link based on the capabilities command. When auto-negotiation is disabled, you
must manually specify the link attributes with the speed-duplex and flowcontrol
commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal configuration will also be
disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (4-190)
speed-duplex (4-188)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#