Installation manual

4-186
SIGNAMAX LLC • www.signamax.eu
Interface Commands
These commands are used to display or set communication parameters for an Ethernet
port, aggregated link, or VLAN.
interface
This command configures an interface type and enters interface configuration mode. Use
the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
• vlan vlan-id (Range: 1-4094)
Table 4-50 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-186
description Adds a description to an interface configuration IC 4-187
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-188
negotiation Enables autonegotiation of a given interface IC 4-189
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-190
flowcontrol Enables flow control on a given interface IC 4-191
media-type Forces port type selected for combination ports IC 4-192
shutdown Disables an interface IC 4-192
switchport broadcast
packet-rate
Configures the broadcast storm control threshold IC 4-193
clear counters Clears statistics on an interface PE 4-194
show interfaces status Displays status for the specified interface NE, PE 4-194
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-196
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-197