Installation manual

4-182
SIGNAMAX LLC • www.signamax.eu
permit, deny (MAC ACL)
This command adds a rule to a MAC ACL. The rule filters packets matching a specified
MAC source or destination address (i.e., physical layer address), or Ethernet protocol
type. Use the no form to remove a rule.
Syntax
[no]
{ permit | deny }
{
any | host source | source address-bitmask}
{
any | host destination | destination address-bitmask}
[
cos cos cos-bitmask] [ vid vid vid-bitmask]
[
ethertype protocol [protocol-bitmask]]
Note: The default is for Ethernet II packets.
[no] { permit | deny } tagged-eth2
{
any | host source | source address-bitmask}
{
any | host destination | destination address-bitmask}
[
cos cos cos-bitmask] [ vid vid vid-bitmask]
[
ethertype protocol [protocol-bitmask]]
[no] { permit | deny } untagged-eth2
{ any | host source | source address-bitmask}
{
any | host destination | destination address-bitmask}
[
ethertype protocol [protocol-bitmask]]
[no] { permit | deny } tagged-802.3
{
any | host source | source address-bitmask}
{
any | host destination | destination address-bitmask}
[
cos cos cos-bitmask] [ vid vid vid-bitmask]
[no] { permit | deny } untagged-802.3
{
any | host source | source address-bitmask}
{
any | host destination | destination address-bitmask}
• tagged-eth2 – Tagged Ethernet II packets.
• untagged-eth2 – Untagged Ethernet II packets.
• tagged-802.3 – Tagged Ethernet 802.3 packets.
• untagged-802.3 – Untagged Ethernet 802.3 packets.
• any – Any MAC source or destination address.
• host – A specific MAC address.
• source – Source MAC address.
• destination – Destination MAC address range with bitmask.
• address-
bitmask
25
– Bitmask for MAC address (in hexidecimal format).
• cos – Class-of-Service value (Range: 0-7)
•
cos-bitmask – Class-of-Service bitmask. (Range: 0-7)
• vid – VLAN ID. (Range: 1-4094)
25. For all bitmasks, “1” means care and “0” means ignore.