Installation manual

4-175
SIGNAMAX LLC • www.signamax.eu
access-list ip
This command adds an IP access list and enters configuration mode for standard or
extended IP ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the source IP address.
• extended – Specifies an ACL that filters packets based on the source or
destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters, no spaces)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL, use
the permit or deny command to add new rules to the bottom of the list. To create
an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the exact
text of a previously configured rule.
• An ACL can contain up to 100 rules.
Example
Related Commands
permit, deny 4-176
ip access-group (4-179)
show ip access-list (4-179)
Console(config)#access-list ip standard david
Console(config-std-acl)#