Installation manual

4-154
SIGNAMAX LLC • www.signamax.eu
Default Setting
1024
Command Mode
Interface Config
Example
clear network-access
Use this command to clear entries from the secure MAC addresses table.
Syntax
clear network-access mac-address-table [static | dynamic]
[address mac-address] [interface interface]
• static - Specifies static address entries.
• dynamic - Specifies dynamic address entries.
• mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)
• interface - Specifies a port interface.
• ethernet unit/port
- unit - This is unit 1.
- port - Port number. (Range: 1-28)
Default Setting
None
Command Mode
Privileged Exec
Example
show network-access
Use this command to display the MAC authentication settings for port interfaces.
Syntax
show network-access [interface interface]
• interface - Specifies a port interface.
• ethernet unit/port
- unit - This is unit 1.
- port - Port number. (Range: 1-28)
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
Console#clear network-access mac-address-table interface ethernet 1/1
Console#