Installation manual

4-142
SIGNAMAX LLC • www.signamax.eu
- max-req – Maximum number of times a port will retransmit an
EAP request/identity packet to the client before it times
out the authentication session (page 4-136).
- Status – Authorization status (authorized or not).
- Operation Mode – Shows if single or multiple hosts (clients) can connect
to an 802.1X-authorized port.
- Max Count – The maximum number of hosts allowed to access this
port (page 4-137).
- Port-control – Shows the dot1x mode on a port as auto,
force-authorized, or force-unauthorized (page 4-136).
- Supplicant – MAC address of authorized client.
- Current Identifier – The integer (0-255) used by the Authenticator to
identify the current authentication session.
- Intrusion action – Shows whether the switch will block all non-EAP traffic
or assign traffic on the port to a guest VLAN if
authentication fails.
• Authenticator State Machine
- State – Current state (including initialize, disconnected,
connecting, authenticating, authenticated, aborting, held,
force_authorized, force_unauthorized).
- Reauth Count – Number of times connecting state is re-entered.
• Backend State Machine
- State – Current state (including request, response, success, fail,
timeout, idle, initialize).
- Request Count – Number of EAP Request packets sent to the Supplicant
without receiving a response.
- Identifier (Server) – Identifier carried in the most recent EAP Success, Failure
or Request packet received from the Authentication
Server.
• Reauthentication State Machine
- State – Current state (including initialize, reauthenticate).