Installation manual

4-116
SIGNAMAX LLC • www.signamax.eu
aaa accounting commands
This command enables the accounting of Exec mode commands. Use the no form to
disable the accounting service.
Syntax
aaa accounting commands level {default | method-name} start-stop group
{tacacs+ |server-group}
no aaa accounting commands level {default | method-name}
• level - The privilege level for executing commands. (Range: 0-15)
• default - Specifies the default accounting method for service requests.
• method-name - Specifies an accounting method for service requests. (Range:
1-255 characters)
• start-stop - Records accounting from starting point and stopping point.
• group - Specifies the server group to use.
- tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server host
command described on page 4-108.
- server-group - Specifies the name of a server group configured with the aaa
group server command described on 4-112. (Range: 1-255 characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
• The accounting of Exec mode commands is only supported by TACACS+ servers.
• Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified TACACS+ server, and do not
actually send any information to the server about the methods to use.
Example
Console(config)#aaa accounting commands 15 default start-stop group
tacacs+
Console(config)#