Installation manual

4-114
SIGNAMAX LLC • www.signamax.eu
aaa accounting dot1x
This command enables the accounting of requested 802.1X services for network access.
Use the no form to disable the accounting service.
Syntax
aaa accounting dot1x {default | method-name} start-stop group {radius |
tacacs+ |server-group}
no aaa accounting dot1x {default | method-name}
• default - Specifies the default accounting method for service requests.
• method-name - Specifies an accounting method for service requests. (Range:
1-255 characters)
• start-stop - Records accounting from starting point and stopping point.
• group - Specifies the server group to use.
- radius - Specifies all RADIUS hosts configure with the radius-server host
command described on page 4-103.
- tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server host
command described on page 4-108.
- server-group - Specifies the name of a server group configured with the aaa
group server command described on 4-112. (Range: 1-255 characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+ servers,
and do not actually send any information to the servers about the methods to use.
Example
Console(config)#aaa accounting dot1x default start-stop group radius
Console(config)#