Installation manual

4-81
SIGNAMAX LLC • www.signamax.eu
upnp device
This command enables UPnP on the device. Use the no form to disable UPnP.
Syntax
[no] upnp device
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
You must enable UPnP before you can configure time out settings for sending of UPnP
messages.
Example
In the following example, UPnP is enabled on the device.
Related Commands
upnp device ttl (4-81)
upnp device advertise duration (4-82)
upnp device ttl
This command sets the time-to-live (TTL) value for sending of UPnP messages from the
device.
Syntax
upnp device ttl value
value - The number of router hops a UPnP packet can travel before it is
discarded. (Range:1-255)
Table 4-1 UPnP Commands
Command Function Mode Page
upnp device Enables/disables UPnP on the network GC 4-81
upnp device ttl Sets the time-to-live (TTL) value. GC 4-81
upnp device advertise
duration
Sets the advertisement duration of the device GC 4-82
show upnp Displays UPnP status and parameters PE 4-82
Console(config)#upnp device
Console(config)#