Installation manual

4-79
SIGNAMAX LLC • www.signamax.eu
Command Usage
• The maximum number of cluster Members is 36.
• The maximum number of switch Candidates is 100.
Example
rcommand
This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-36)
Command Mode
Privileged Exec
Command Usage
• This command only operates through a Telnet connection to the Commander
switch. Managing cluster Members using the local console CLI on the Commander
is not supported.
• There is no need to enter the username and password for access to the Member
switch CLI
.
Example
show cluster
This command shows the switch clustering configuration.
Command Mode
Privileged Exec
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
Vty-0#rcommand id 1
CLI session with the 24 port 10/100 Managed
Layer 2 Switch with 4 x Gigabit Combo ports is opened.
To end the CLI session, enter [Exit].
Vty-0#
Console#show cluster
Role: commander
Interval heartbeat: 30
Heartbeat loss count: 3
Number of Members: 1
Number of Candidates: 2
Console#