Installation manual

4-68
SIGNAMAX LLC • www.signamax.eu
Command Mode
Global Configuration
Command Usage
You can enable NTP authentication to ensure that reliable updates are received
from only authorized NTP servers. The authentication keys and their associated key
number must be centrally managed and manually distributed to NTP servers and
clients. The key numbers and key values must match on both the server and client.
Example
Related Commands
ntp authentication-key (4-68)
ntp authentication-key
This command configures key numbers and corresponding authentication keys to use
when NTP authentication is enabled. Use the no form of the command to clear a specific
authentication key or all keys from the current list.
Syntax
ntp authentication-key number md5 key
no ntp authentication-key [number]
• number - The NTP authentication key ID number. (Range: 1-65535)
• md5 - Specifies that authentication is provided by using the message digest
algorithm 5.
• key - An MD5 authentication key string. The key string can be up to 32
case-sensitive printable ASCII characters (no spaces).
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The key number specifies a key value in the NTP authentication key list. Up to 255
keys can be configured on the switch. Re-enter this command for each key you
want to configure.
• Note that NTP authentication key numbers and values must match on both the
server and client.
• NTP authentication is optional. When enabled with the ntp authenticate
command, you must also configure at least one key number using this command.
Console(config)#ntp authenticate
Console(config)#