Installation manual

4-65
SIGNAMAX LLC • www.signamax.eu
show sntp
This command displays the current time and configuration settings for the SNTP client,
and indicates whether or not the local time has been properly updated.
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command displays the current time, the poll interval used for sending time
synchronization requests, and the current SNTP mode (i.e., unicast).
Example
ntp client
This command enables NTP client requests for time synchronization from NTP time
servers specified with the ntp servers command. Use the no form to disable NTP client
requests.
Syntax
[no] ntp client
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• SNTP and NTP clients cannot be enabled at the same time. First disable the SNTP
client before using this command.
• The time acquired from time servers is used to record accurate dates and times for
log events. Without NTP, the switch only records the time starting from the factory
default set at the last bootup (i.e., 00:00:00, Jan. 1, 2001).
• This command enables client time requests to time servers specified via the ntp
servers command. It issues time synchronization requests based on the interval
set via the ntp poll command.
Console#show sntp
Current time: Dec 23 05:13:28 2002
Poll interval: 16
Current mode: unicast
SNTP status : Enabled
SNTP server 137.92.140.80 0.0.0.0 0.0.0.0
Current server: 137.92.140.80
Console#