Installation manual

4-54
SIGNAMAX LLC • www.signamax.eu
Command Usage
• Use this command more than once to build up a list of host IP addresses.
• The maximum number of host IP addresses allowed is five.
Example
logging facility
This command sets the facility type for remote logging of syslog messages. Use the no
form to return the type to the default.
Syntax
[no] logging facility type
type - A number that indicates the facility used by the syslog server to dispatch
log messages to an appropriate service. (Range: 16-23)
Default Setting
23
Command Mode
Global Configuration
Command Usage
The command specifies the facility type tag sent in syslog messages. (See RFC
3164.) This type has no effect on the kind of messages reported by the switch.
However, it may be used by the syslog server to sort messages or to store
messages in the corresponding database.
Example
logging trap
This command enables the logging of system messages to a remote server, or limits the
syslog messages saved to a remote server based on severity. Use this command without
a specified level to enable remote logging. Use the no form to disable remote logging.
Syntax
logging trap [level]
no logging trap
level - One of the level arguments listed below. Messages sent include the
selected level up through level 0. (Refer to the table on page 4-52.)
Console(config)#logging host 10.1.0.3
Console(config)#
Console(config)#logging facility 19
Console(config)#