Installation manual

4-52
SIGNAMAX LLC • www.signamax.eu
logging on
This command controls logging of error messages, sending debug or error messages to
switch memory. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent to
remote syslog servers. You can use the logging history command to control the
type of error messages that are stored in memory. You can use the logging trap
command to control the type of error messages that are sent to specified syslog
servers.
Example
Related Commands
logging history (4-52)
logging trap (4-54)
clear log (4-55)
logging history
This command limits syslog messages saved to switch memory based on severity. The
no form returns the logging of syslog messages to the default level.
Syntax
logging history {flash | ram} level
no logging history {flash | ram}
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on power
reset).
Console(config)#logging on
Console(config)#