Installation manual

4-41
SIGNAMAX LLC • www.signamax.eu
whichboot
This command displays which files were booted when the system powered up.
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See the
table under the dir command for a description of the file information displayed by this
command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Console#whichboot
File name File type Startup Size (byte)
-------------------------------- -------------- ------- -----------
Unit1:
065-7729_diag_V1.0.0.8.bix Boot-Rom Image Y 1383604
065-7729_runtime_V1.1.3.4.bix Operation Code Y 3843400
startup1.cfg Config File Y 4721
Console#
Console(config)#boot system config: startup
Console(config)#