Installation manual

4-37
SIGNAMAX LLC • www.signamax.eu
• startup-config - The configuration used for system initialization.
• tftp - Keyword that allows you to copy to/from a TFTP server.
• https-certificate - Copies an HTTPS certificate from an TFTP server to the
switch.
• public-key - Keyword that allows you to copy a SSH key from a TFTP server.
(“Secure Shell Commands” on page 4-125)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading letter of the
file name should not be a period (.), and the maximum length for file names on the
TFTP server is 127 characters or 31 characters for files on the switch. (Valid
characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the switch supports only one operation
code file.
• The maximum number of user-defined configuration files depends on available
memory.
• You can use “Factory_Default_Config.cfg” as the source to copy from the factory
default configuration file, but you cannot use it as the destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• The Boot ROM and Loader cannot be uploaded or downloaded from the TFTP
server. You must follow the instructions in the release notes for new firmware, or
contact your distributor for help.
• For information on specifying an https-certificate, see “Replacing the Default
Secure-site Certificate” on page 3-78. For information on configuring the switch to
use HTTPS for a secure connection, see “ip http secure-server” on page 4-122.
Example
The following example shows how to download new firmware from a TFTP server:
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: V1.0.0.5.bix
Destination file name: V1.0.0.5.bix
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#