Installation manual

4-31
SIGNAMAX LLC • www.signamax.eu
show running-config
This command displays the configuration information currently in use.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show startup-config command to
compare the information in running memory to the information stored in non-volatile
memory.
• This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
- Switch’s MAC address
- SNTP and NTP server settings
- 802.1Q tunnel settings
- Broadcast storm control settings
- SNMP community strings
- Users (names and access levels)
- Event log settings
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- Multiple spanning tree instances (name and interfaces)
- IP address configured for the switch
- Spanning tree settings
- Interface settings
- Any configured settings for the console port and Telnet