Installation manual

4-28
SIGNAMAX LLC • www.signamax.eu
Example
System Status Commands
This section describes commands used to display system information.
show startup-config
This command displays the configuration file stored in non-volatile memory that is used to
start up the system.
Default Setting
None
Command Mode
Privileged Exec
Console#show banner
SIGNAMAX_LLC.
WARNING - MONITORED ACTIONS AND ACCESSES
R&D
Albert_Einstein - 123-555-1212
Lamar - 123-555-1219
Station's information:
710_Network_Path,_Indianapolis
SIGNAMAX_LLC. - 2852SIGNAMAX-PoE
Floor / Row / Rack / Sub-Rack
3 / 10 / 15 / 12
DC power supply:
Power Source A: Floor / Row / Rack / Electrical circuit
3 / 15 / 24 / 48v-id_3.15.24.2
Number of LP: 12
Position MUX: telco-8734212kx_PVC-1/23
IP LAN: 192.168.1.1/255.255.255.0
Note:
!!!!!ROUTINE_MAINTENANCE_firmware-upgrade_0100-0500_GMT-0500_20071022!!!!
!_20min_network_impact_expected
Console#
Table 4-9 System Status Commands
Command Function Mode Page
show startup-config Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
PE 4-28
show running-config Displays the configuration data currently in use PE 4-31
show system Displays system information NE, PE 4-33
show users Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
NE, PE 4-33
show version Displays version information for the system NE, PE 4-34