Installation manual

4-17
SIGNAMAX LLC • www.signamax.eu
quit
This command exits the configuration program.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
The quit and exit commands can both exit the configuration program.
Example
This example shows how to quit a CLI session:
System Management Commands
These commands are used to control system logs, passwords, user names, browser
configuration options, and display or configure a variety of other system information.
Console#quit
Press ENTER to start session
User Access Verification
Username:
Table 4-6 System Management Commands
Command Group Function Page
Device Designation Configures information that uniquely identifies this switch 4-18
Banner Information Configures administrative contact device identification and location 4-19
System Status Displays system configuration, active managers, and version information 4-28
Frame Size Enables support for jumbo frames 4-35
File Management Manages code image or switch configuration files 4-36
Line Sets communication parameters for the serial port, including baud rate and
console time-out
4-42
Event Logging Controls logging of error messages 4-51
SMTP Alerts Configures SMTP email alerts 4-58
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually 4-62
Switch Clustering Configures management of multiple devices via a single IP address 4-76
UPnP Sets Universal Plug-and-Play parameters used to advertise the switch 4-80
User Access Configures the basic user names and passwords for management access 4-98
IP Filter Configures IP addresses that are allowed management access 4-144