Installation manual

4-15
SIGNAMAX LLC • www.signamax.eu
Command Usage
This command resets the entire system. The switch will wait the designated amount
of time before resetting. If a delayed reset has already been scheduled, then the
newly configured reset will overwrite the original delay configuration. The configured
delay time cannot exceed 24 days (576 hours, or 34560 minutes). If no time is
specified, then the switch will reboot immediately.
Example
This example shows how to reset the switch:
show reload
This command displays the remaining time until a pending delayed reset will take place.
Syntax
show reload
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows how to display the remaining time until a configured delayed reset of
the switch will take place:
prompt
This command customizes the CLI prompt. Use the no form to restore the default prompt.
Syntax
prompt string
no prompt
string - Any alphanumeric string to use for the CLI prompt.
(Maximum length: 255 characters)
Default Setting
Console
Console#reload
System will be restarted, continue <y/n>? y
Console#show reload
The switch will be rebooted at Nov 23 22:52:14 2007.
Remaining Time : 0 days, 4 hours, 31 minutes, 46 seconds.
Console#