Installation manual

4-5
SIGNAMAX LLC • www.signamax.eu
The command “show interfaces ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match the initial
letters are provided. (Remember not to leave a space between the command and
question mark.) For example “show s?” shows all the keywords starting with “s.”
Negating the Effect of Commands
For many configuration commands you can enter the prefix keyword “no” to cancel the
effect of a command or reset the configuration to the default value. For example, the
logging command will log system messages to a host server. To disable logging, specify
the no logging command. This guide describes the negation effect for all applicable
commands.
Using Command History
The CLI maintains a history of commands that have been entered. You can scroll back
through the history of commands by pressing the up arrow key. Any command displayed
in the history list can be executed again, or first modified and then executed.
Using the show history command displays a longer list of recently executed commands.
version System hardware and software versions
vlan Virtual LAN settings
voice Shows the voice VLAN information
web-auth Shows web authentication configuration
Console#show
Console#show interfaces ?
counters Interface counters information
status Interface status information
switchport Interface switchport information
Console#show interfaces
Console#show s?
snmp sntp spanning-tree ssh startup-config
system
Console#show s