Installation manual

3-272
SIGNAMAX LLC • www.signamax.eu
Displaying Information on Cluster Candidates
Use the Cluster Candidate Information page to display information about discovered
switches in the network that are already cluster Members or are available to become
cluster Members.
Command Attributes
• Role – Indicates the current status of Candidate switches in the network.
• MAC Address – The MAC address of the Candidate switch.
• Description – The system description string of the Candidate switch.
Web – Click Cluster, Candidate Information.
Figure 3-157 Cluster Candidate Information
CLI – This example shows information about cluster Candidate switches.
UPnP
Universal Plug and Play (UPnP) is a set of protocols that allows devices to connect
seamlessly and simplifies the deployment of home and office networks. UPnP achieves
this by issuing UPnP device control protocols designed upon open, Internet-based
communication standards.
The first step in UPnP networking is discovery. When a device is added to the network,
the UPnP discovery protocol allows that device to broadcast its services to control points
on the network. Similarly, when a control point is added to the network, the UPnP
discovery protocol allows that control point to search for UPnP enabled devices on the
network.
Vty-0#show cluster candidates 4-80
Cluster Candidates:
Role Mac Description
--------------- ----------------- -----------------------------------------
ACTIVE MEMBER 00-12-cf-23-49-c0 24/48 L2/L4 IPV4/IPV6 GE Switch
CANDIDATE 00-12-cf-0b-47-a0 24/48 L2/L4 IPV4/IPV6 GE Switch
Vty-0#