Installation manual

3-267
SIGNAMAX LLC • www.signamax.eu
Configuring Static MVR Receiver Group Members
You can statically assign a multicast reciever group to the selected interface using the
Receiver Group Member Configuration page.
Field Attributes
• Interface – Indicates a port or trunk.
• Group Address List – Multicast receiver groups assigned to the selected interface.
Note that the displayed multicast services have been configured as a receiver group to
be managed through the MVR receiver VLAN (see “Configuring MVR Receiver VLAN
and Group Addresses” on page 3-265).
Web – Click MVR, Receiver Group Member Configuration. Select a port or trunk from the
“Interface” field, select a multicast group address from the member list, and then click the
Add or Remove button to modify the list.
Figure 3-152 Static MVR Receiver Group Member Configuration
CLI – This example sets the type of a port as an MVR receiver, and then statically assigns
an MVR receiver group to the MVR receiver VLAN.
Console(config)#interface ethernet 1/8
Console(config-if)#mvr type receiver 4-333
onsole(config-if)#mvr static-reciever-group 225.0.1.6
onsole(config-if)#