Installation manual

3-259
SIGNAMAX LLC • www.signamax.eu
Web – Click MVR, Configuration. Enable MVR globally on the switch, select the MVR
VLAN, add the multicast groups that will stream traffic to attached hosts, and then click
Apply.
Figure 3-145 MVR Global Configuration
CLI – This example first enables IGMP snooping, enables MVR globally, and then
configures a range of MVR group addresses.
Displaying MVR Interface Status
You can display information about the interfaces attached to the MVR VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
• MVR Status – Shows the MVR status. MVR status for source ports is “ACTIVE” if MVR
is globally enabled on the switch. MVR status for receiver ports is “ACTIVE” only if there
are subscribers receiving multicast traffic from one of the MVR groups, or a multicast
group has been statically assigned to an interface.
• Immediate Leave – Shows if immediate leave is enabled or disabled.
• Trunk Member
20
– Shows if port is a trunk member.
Console(config)#ip igmp snooping 4-314
Console(config)#mvr 4-331
Console(config)#mvr group 228.1.23.1 10 4-331
Console(config)#