Installation manual

3-248
SIGNAMAX LLC • www.signamax.eu
CLI – This example enables IGMP immediate leave for VLAN 1 and then displays the
current IGMP snooping status.
Displaying Interfaces Attached to a Multicast Router
Multicast routers that are attached to ports on the switch use information obtained from
IGMP, along with a multicast routing protocol such as DVMRP or PIM, to support IP
multicasting across the Internet. These routers may be dynamically discovered by the
switch or statically assigned to an interface on the switch.
You can use the Multicast Router Port Information page to display the ports on this switch
attached to a neighboring multicast router/switch for each VLAN ID.
Command Attributes
• VLAN ID – ID of configured VLAN (1-4094).
• Multicast Router List – Multicast routers dynamically discovered by this switch or those
that are statically assigned to an interface on this switch.
Web – Click IGMP Snooping, Multicast Router Port Information. Select the required
VLAN ID from the scroll-down list to display the associated multicast routers.
Figure 3-138 Displaying Multicast Router Port Information
Console(config)#interface vlan 1
Console(config-if)#ip igmp snooping immediate-leave 4-316
Console(config-if)#end
Console#show ip igmp snooping 4-315
Service Status: Enabled
Querier Status: Disabled
Leave proxy status: Enabled
Query Count: 2
Query Interval: 125 sec
Query Max Response Time: 10 sec
Router Port Expire Time: 300 sec
Immediate Leave Processing: Enabled on VLAN 1,
IGMP Snooping Version: Version 2
Console#