Installation manual

3-246
SIGNAMAX LLC • www.signamax.eu
• IGMP Version — Sets the protocol version for compatibility with other devices on the
network. (Range: 1-3; Default: 2)
Notes: 1.
All systems on the subnet must support the same version.
2. Some attributes are only enabled for IGMPv2 and/or v3, including Act as IGMP
Querier, IGMP Report Delay and IGMP Query Timeout.
Web – Click IGMP Snooping, IGMP Configuration. Adjust the IGMP settings as required,
and then click Apply. (The default settings are shown below.)
Figure 3-136 IGMP Configuration
CLI – This example modifies the settings for multicast filtering, and then displays the
current status.
Console(config)#ip igmp snooping 4-314
Console(config)#ip igmp snooping querier 4-318
Console(config)#ip igmp snooping query-count 10 4-319
Console(config)#ip igmp snooping query-interval 100 4-320
Console(config)#ip igmp snooping query-max-response-time 20 4-320
Console(config)#ip igmp snooping router-port-expire-time 300 4-321
Console(config)#ip igmp snooping version 2 4-315
Console(config)#exit
Console#show ip igmp snooping 4-315
Service status: Enabled
Querier status: Enabled
Leave proxy status: Disabled
Query count: 10
Query interval: 100 sec
Query max response time: 20 sec
Router port expire time: 300 sec
Immediate Leave Processing: Disabled on all VLAN
IGMP snooping version: Version 2
Console#