Installation manual

3-228
SIGNAMAX LLC • www.signamax.eu
Enabling IP DSCP Priority
The switch allows you to enable or disable the IP DSCP priority.
Command Attributes
• IP DSCP Priority Status – The following options are:
- Disabled – Disables the priority service. (Default Setting: Disabled)
- IP DSCP – Maps layer 3/4 priorities using Differentiated Services Code Point
Mapping.
Web – Click Priority, IP DSCP Priority Status. Select IP DSCP from the drop down menu,
then click Apply.
Figure 3-128 IP DSCP Priority Status
CLI – The following example globally enables DSCP Priority service on the switch.
Console(config)#map ip dscp 4-301
Console(config)#end
Console#show map ip dscp 4-302
dscp Mapping Status: Enabled
DSCP COS
---- ---
0 1
1 0
2 0
3 0
.
.
.