Installation manual

3-225
SIGNAMAX LLC • www.signamax.eu
Web – Click Priority, Traffic Classes. The current mapping of CoS values to output
queues is displayed. Assign priorities to the traffic classes (i.e., output queues), then click
Apply.
Figure 3-125 Traffic Classes
CLI – The following example shows how to change the CoS assignments.
* Mapping specific values for CoS priorities is implemented as an interface configuration command,
but any changes will apply to the all interfaces on the switch.
Console(config)#interface ethernet 1/1 4-186
Console(config-if)#queue cos-map 0 0 4-298
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1 4-300
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 1 2 2 3 3
Console#