Installation manual

3-212
SIGNAMAX LLC • www.signamax.eu
Web – Click LLDP, Port/Trunk Configuration. Set the LLDP transmit/receive mode,
specify whether or not to send SNMP trap messages, select the information to advertise
in LLDP messages, select the information to advertise in MED-TLV messages and
specify whether or not to send MED notifications. Then click Apply.
Figure 3-118 LLDP Port Configuration
CLI – This example sets the interface to both transmit and receive LLDP messages,
enables SNMP trap messages, enables MED notification, and specifies the TLV,
MED-TLV, dot1-TLV and dot3-TLV parameters to advertise.
Console(config)#interface ethernet 1/1 4-186
Console(config-if)#lldp admin-status tx-rx 4-279
Console(config-if)#lldp notification 4-280
Console(config-if)#lldp medNotification 4-281
Console(config-if)#lldp basic-tlv port-description 4-282
Console(config-if)#lldp basic-tlv system-description 4-283
Console(config-if)#lldp basic-tlv management-ip-address 4-281
Console(config-if)#lldp basic-tlv system-name 4-284
Console(config-if)#lldp basic-tlv system-capabilities 4-283
Console(config-if)#lldp medtlv extPoe 4-288
Console(config-if)#lldp medtlv inventory 4-289
Console(config-if)#lldp medtlv location 4-289
Console(config-if)#lldp medtlv med-cap 4-290
Console(config-if)#lldp medtlv network-policy 4-290
Console(config-if)#lldp dot1-tlv proto-ident 4-284
Console(config-if)#lldp dot1-tlv proto-vid 4-285
Console(config-if)#lldp dot1-tlv pvid 4-285
Console(config-if)#lldp dot1-tlv vlan-name 4-286
Console(config-if)#lldp dot3-tlv link-agg 4-286
Console(config-if)#lldp dot3-tlv mac-phy 4-287
Console(config-if)#lldp dot3-tlv max-frame 4-287
Console(config-if)#lldp dot3-tlv poe 4-288
Console(config-if)#