Installation manual

3-204
SIGNAMAX LLC • www.signamax.eu
Web – Click VLAN, Private VLAN, Port Configuration or Trunk Configuration. Set the
PVLAN Port Type for each port that will join a private VLAN. Assign promiscuous ports to
a primary VLAN. Assign host ports to a community VLAN. After all the ports have been
configured, click Apply.
Figure 3-114 Private VLAN Port Configuration
CLI – This example shows the switch configured with primary VLAN 5 and secondary
VLAN 6. Port 3 has been configured as a promiscuous port and mapped to VLAN 5, while
ports 4 and 5 have been configured as a host ports and associated with VLAN 6. This
means that traffic for port 4 and 5 can only pass through port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport mode private-vlan promiscuous 4-261
Console(config-if)#switchport private-vlan mapping 5 4-262
Console(config-if)#exit
Console(config)#interface ethernet 1/4
Console(config-if)#switchport mode private-vlan host 4-261
Console(config-if)#switchport private-vlan host-association 6 4-261
Console(config-if)#exit
Console(config)#interface ethernet 1/5
Console(config-if)#switchport mode private-vlan host
Console(config-if)#switchport private-vlan host-association 6
Console(config-if)#