Installation manual

3-188
SIGNAMAX LLC • www.signamax.eu
Adding Static Members to VLANs (Port Index)
Use the VLAN Static Membership by Port menu to assign VLAN groups to the selected
interface as a tagged member.
Command Attributes
• Interface – Port or trunk identifier.
• Member – VLANs for which the selected interface is a tagged member.
• Non-Member – VLANs for which the selected interface is not a tagged member.
Web – Open VLAN, 802.1Q VLAN, Static Membership by Port. Select an interface from
the scroll-down box (Port or Trunk). Click Query to display membership information for the
interface. Select a VLAN ID, and then click Add to add the interface as a tagged member,
or click Remove to remove the interface. After configuring VLAN membership for each
interface, click Apply.
Figure 3-104 VLAN Static Membership by Port
CLI – This example adds Port 3 to VLAN 1 as a tagged port, and removes Port 3 from
VLAN 2.
Console(config)#interface ethernet 1/3 4-186
Console(config-if)#switchport allowed vlan add 1 tagged 4-247
Console(config-if)#switchport allowed vlan remove 2
Console(config-if)#