Installation manual

3-184
SIGNAMAX LLC • www.signamax.eu
CLI – Current VLAN information can be displayed with the following command.
Creating VLANs
Use the VLAN Static List to create or remove VLAN groups. To propagate information
about VLAN groups used on this switch to external network devices, you must specify a
VLAN ID for each of these groups.
Command Attributes
• Current – Lists all the current VLAN groups created for this system. Up to 256 VLAN
groups can be defined. VLAN 1 is the default untagged VLAN. VLAN 4093 is reserved
for switch clustering and is not user-configurable or removable.
• New – Allows you to specify the name and numeric identifier for a new VLAN group.
(The VLAN name is only used for management on this system; it is not added to the
VLAN tag.)
• VLAN ID – ID of configured VLAN (1-4094, no leading zeroes).
• VLAN Name – Name of the VLAN (1 to 32 characters, no spaces).
• Status (Web) – Enables or disables the specified VLAN.
- Enabled: VLAN is operational.
- Disabled: VLAN is suspended; i.e., does not pass packets.
• State (CLI) – Enables or disables the specified VLAN.
- Active: VLAN is operational.
- Suspend: VLAN is suspended; i.e., does not pass packets.
• Add – Adds a new VLAN group to the current list.
• Remove – Removes a VLAN group from the current list. If any port is assigned to this
group as untagged, it will be reassigned to VLAN group 1 as untagged.
Console#show vlan id 1 4-249
Default VLAN ID : 1
VLAN ID: 1
Type: Static
Name: DefaultVlan
Status: Active
Ports/Port Channels: Eth1/ 1(S) Eth1/ 2(S) Eth1/ 3(S) Eth1/ 4(S) Eth1/ 5(S)
Eth1/ 6(S) Eth1/ 7(S) Eth1/ 8(S) Eth1/ 9(S) Eth1/10(S)
Eth1/11(S) Eth1/12(S) Eth1/13(S) Eth1/14(S) Eth1/15(S)
Eth1/16(S) Eth1/17(S) Eth1/18(S) Eth1/19(S) Eth1/20(S)
Eth1/21(S) Eth1/22(S) Eth1/23(S) Eth1/24(S) Eth1/25(S)
Eth1/26(S) Eth1/27(S) Eth1/28(S)
Console#